Identification of The Presence of Water in The Production Fluid Distribution Process in the Offshore Oil Field
DOI:
https://doi.org/10.31315/e.v17i2.3718Keywords:
Kadar air, BS&W, produksi minyak, produksi airAbstract
Oil production that flows from the Platform to the FSO (Floating Storage and Offloading) "A" is derived from PT. "B" and the "C" Oil Company in the Madura Strait. The total oil production flowing from the Platform to the "A" FSO is currently around 6000 BOPD. As a result of the delivery system using the same channel, a problem arises, namely oil losses between the Platform as a delivery point and FSO "A" as a receiving point. Besides that, the water that is involved in the oil distribution process will be a deduction factor that will be used as a correction for oil shipments, the more water the less amount of oil will be received at FSO "A". The oil samples that have been taken are then observed for their characteristics, namely density, composition (%-mole), BS&W, emulsion, flash, shrinkage at PPPTMGB "Lemigas" Laboratory Jakarta. The specific gravity of samples is around 1,018. While the characteristics of the two are different from the characteristics of sea water; this difference is shown by the results of SG (1,018 vs 1,025) and the salt content of sea water is much higher than the water formation of PT "B" and PT "C". The oil samples of PT "B" and PT "C" have almost the same SG, which is 0.79. BS&W oil in both ships is quite low; this shows that the separation of oil and water on the Platform went quite well. However, BS&W samples in incoming FSO "A" are very high, at 5%; this indicates an off-set at the water-oil interface level settling time on the Platform separator so that water can be joined with the oil flow from the Platform to the FSO "A"References
Intertanko, 1996. Oil Cargo Losses and Problems with Measurement 2nd Edition. International Association of Independent Tanker Owners, London
Jones, P., 1985. Oil loss, measurement and control. A paper presented to the Chinese Petroleum Society, China, July: 2–29
Manual of Petroleum Measurement Satandards Chapter 10, Sediment and Water, Third Editions, 2008
API MPMS Chapter 10.2 (1'st Edition 1981 - Reaffirmed 2005)
Analisa BS & W By CentrifugeASTM – D - 6/API-2542
Downloads
Published
How to Cite
Issue
Section
License
Authors who publish with this journal agree to the following terms:
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International License(CC BY SA 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Eksergi allows authors retain the copyright and full publishing rights without restrictions.