Analysis of Tensile and Bending Strength of Coconut Fiber Reinforcement Composite on Quasi Isotropic Laminates Stacking Sequence
DOI:
https://doi.org/10.31315/jmept.v4i2.11350Abstract
A composite is a material structure composed of two or more combinations of constituents combined macroscopically, where the two combinations do not dissolve each other. The first phase is called reinforcement, while the second phase is called matrix. This study aims to analysis the tensile and bending strength values of coconut fiber reinforced composites with a sequence of layers of quasi-isotropic fiber laminates. Experimental studies were carried out on polyester resin composites reinforced with coconut fiber in the fiber layer sequences of [0°/0°/0°], [+45°/0°/-45°] and [+60°/0°/-60°]. Tensile test specimen standards refer to ASTM D-3039 and bending test standards refer to ASTM D-7264. The results of the blistering test obtained a maximum stress of 18.3298 N/mm2 in the fiber layer sequence [0°/0°/0°] and a minimum stress of 10.8966 N/mm2 in the fiber layer sequence [+60°/0°/ -60°]. Meanwhile, the bending test results showed that the maximum bending stress was 76.065 N/mm2 in the fiber layer sequence [0°/0°/0°] and the minimum stress was 30.256 N/mm2 in the fiber layer sequence [+45°/0°/-45 °].
Downloads
Published
Issue
Section
License
Authors who publish in Journal of Metallurgical Engineering and Processing Technology agree to the following terms:
Authors who publish articles in this journal agree to the following terms:
- Copyright remains with the author and gives rights to the Journal of Metallurgical Engineering and Processing Technology as the priority to publish the article with an Creative Commons Atribusi 4.0 Internasional License, which allows the article to be shared with acknowledgment of the author of the article and this journal as the place of publication.
- Authors can distribute the publication of their articles on a non-exclusive basis (for example: on university repositories or books) with notification or acknowledgment of publication in the journal Option
- Authors are allowed to post their work online (for example: on personal websites or in university repositories) before and after the submission process (see The Effect of Open Access)
Journal of Metallurgical Engineering and Processing Technology is licensed under a Creative Commons Atribusi 4.0 Internasional License.