ROTARY DEGASSER DI CV. C-MAXI ALLOY ALUMUNIUM

Authors

  • Sudaryanto Sudaryanto Universitas Pembangunan Nasional "Veteran' Yogyakarta
  • Muhammad Fauzan Bawono Putra Universitas Pembangunan Nasional "Veteran' Yogyakarta

DOI:

https://doi.org/10.31315/jmept.v2i1.4859

Keywords:

Rotary degasser, Porositas gas

Abstract

Rotary degasser merupakan salah satu alat yang digunakan dalam industri pengecoran untuk menghilangkan gas hidrogen dan kotoran padat dari paduan aluminium cair atau proses degassing. Penggunaan alat ini digunakan untuk mengurangi cacat yaitu porositas gas. Porositas gas ini terbentuk pada saat logam berada pada tungku dan menjadi logam leleh. Pada saat ini logam sangat mudah berikatan dengan lingkungan sekitarnya. Dilakukan dengan pengamatan secara visual di CV. C-Maxi Alloy Aluminium.

References

Rajkolhe,Rajesh dan Khan,J.G. 2014.Defect, Causes and Their Remedies

in Casting Process:A Riview. Shegaon:

Shri Sant Gajanan Collage of Engineering.

Sigworth, G. K. 2011. Quality issues in

aluminum castings. Fundamentals of

Aluminium Metallurgy. p.155–184.

V.S. Warke,dkk. 2004. Journal of

Materials Processing Technology 168

(2005) 119–126

Mathematical modeling and computer

simulation of molten

aluminumcleansing by the rotating

impeller degasserPart II. Removal of

hydrogen gas and solid particle. USA:

Worcester Polytechnic Institute, Advanced Casting Research Center .

Universitas Sumatera Utara Repositori

Institusi . 2019. Perbaikan Sifat Fisik dan

MekanikAluminium A356 yang

Dipadukan dengan Titanium Karbida

(TiC) 0.15%,0.17% dan 0.19%

MenggunakanCooling Slope dengan

Kemiringan 75. Sumetera Utara:

Departemen Teknik Mesin Skripsi

Sarjana.

Rajkolhe,Rajesh dan Khan,J.G. 2014. Defect, Causes and Their Remedies in

Casting Process:A Riview.Shri Sant

Gajanan Collage of Engineering: Shegaon

Downloads

Published

2021-06-23

Issue

Vol 2, No 1 (August 2021)

Section

Articles

License

Authors who publish in Journal of Metallurgical Engineering and Processing Technology agree to the following terms:

  1. Authors who publish articles in this journal agree to the following terms:

    1. Copyright remains with the author and gives rights to the Journal of Metallurgical Engineering and Processing Technology as the priority to publish the article with an Creative Commons Atribusi 4.0 Internasional License, which allows the article to be shared with acknowledgment of the author of the article and this journal as the place of publication.
    2. Authors can distribute the publication of their articles on a non-exclusive basis (for example: on university repositories or books) with notification or acknowledgment of publication in the journal Option
    3. Authors are allowed to post their work online (for example: on personal websites or in university repositories) before and after the submission process (see The Effect of Open Access)

    Journal of Metallurgical Engineering and Processing Technology is licensed under a Creative Commons Atribusi 4.0 Internasional License.