PENGECORAN PULLEY B3 x 6 INCH DAN ANALISIS CACAT DALAM PENGECORAN
DOI:
https://doi.org/10.31315/jmept.v1i2.5039Keywords:
Pengecoran daur ulang, Pully, Besi cor, proses produksi, analisis cacatAbstract
Pengecoran daur ulang logam merupakan salah satu alternatif pengembangan industri pengecoran di Indonesia. Pully merupakan salah satu produk hasil pengecoran dengan bahan dari besi cor yang digunakan sebagai alat penggerak mesin traktor. Bahan baku dari besi cor yang diproduksi di PT Mitra Rekatama Mandiri sendiri terdiri dari skrap sisa peleburan, gram, arang, silika dan penambahan slag remover. Besi cor yang dihasilkan dari PT. Mitra Rekatama Mandiri terdiri dari besi cor FC (Ferro Carbon/ besi cor kelabu) dan besi cor FCD (Ferro Carbon Ductile/ besi cor nodular) yang dihasilkan dalam tungku induksi di suhu ±1200oC. Hasil peleburan kemudian dituangkan kedalam cetakan pasir basah menggunakan ladle, kemudian hasil coran dibersihkan dan pengecekan cacat (quality control) sebelum dilakukan proses permesinan dan finishing. Dalam penulisan jurnal ini penulis ingin memfokuskan penulisan pada proses produksi dan analisis cacat pada pengecoran pully yang ada di PT. Mitra Rekatama Mandiri untuk mesin traktor.References
Ali Rosyidin, 2017. Proses Pembuatan Alat
Pembuka Kaleng Cat dengan Metode
Cetak Pasir. Universitas Muhammadiyah
Tangerang, Vol. 6, No. 1.
I Made Astika, DNK Putra Negara, Made
Agus Susantika. 2010. Pengaruh Jenis
Pasir Cetak dengan Zat Pengikat
Bentonit Terhadap Sifat Permeabilitas
dan Kekuatan Tekan Basah Cetakan
Pasir (Sand Casting). Jurnal Ilmiah
Teknik Mesin Vol. 4, No.2.
Sai dkk. 2017. A Critical Review on Casting
Types and Defects. India: 2017 IJSRSET
Volume 3, Issue 2.
Surdia, T; Chijiwa, K., 2000, Teknik
Pengecoran Logam, Cetakan ke-8, PT.
Pradnya Paramita, Jakarta
Van Vlack, L. H., 1992, Ilmu dan Teknologi
Bahan, PT. Gelora Aksara Pratama,
Jakarta
Downloads
Published
Issue
Section
License
Authors who publish in Journal of Metallurgical Engineering and Processing Technology agree to the following terms:
Authors who publish articles in this journal agree to the following terms:
- Copyright remains with the author and gives rights to the Journal of Metallurgical Engineering and Processing Technology as the priority to publish the article with an Creative Commons Atribusi 4.0 Internasional License, which allows the article to be shared with acknowledgment of the author of the article and this journal as the place of publication.
- Authors can distribute the publication of their articles on a non-exclusive basis (for example: on university repositories or books) with notification or acknowledgment of publication in the journal Option
- Authors are allowed to post their work online (for example: on personal websites or in university repositories) before and after the submission process (see The Effect of Open Access)
Journal of Metallurgical Engineering and Processing Technology is licensed under a Creative Commons Atribusi 4.0 Internasional License.